SAFETY INSTRUCTIONS Maintenance Text-module Advice for front loader maintenance: 1.Before undertaking maintenance work, lower the front loader to the ground, switch off the engine and remove the ignition key. 2.If the pipe fracture protection has engaged, support the load before starting repairs, and slowly retract the cylinder. 3.Hydraulic hoses deteriorate with age. Check the condition of hydraulic hoses at regular intervals, and replace them in good time. 4.After attachment and repair operations, drive the tractor for a short time then retighten all mounting screws and nuts and check them regularly. 5.Retighten eccentric bolt for front loader attachment, if necessary.
1.Before maintenance and repair work, switch off the engine and remove the ignition key. Relieve pressure from implement lines, e.g. to the front loader. 2.Any person should keep clear of a lifted, unsecured load (e.g. tilted cab and similar). 3.Never open or remove any protection devices while the engine is running. 4.Never grasp leaking pressure lines. Pressurised fluids (diesel or hydr. oil) escaping under high pressure can penetrate the skin and cause severe injuries. If this has occurred, seek medical advice at once to avoid the risk of serious infection. 5.Keep at a safe distance from hot areas. 6.Hydraulic accumulator and connected pipes are highly pressurised.
Only remove and repair in accordance with instructions provided in Technical Manual. 7.To avoid eye injury, do not look directly at the surface of the activated radar sensor. 8.Dispose of oil, fuels and filters properly! 9.For fitting tires, specialist knowledge and special mounting tools are required. 10.Run the tractor for a short time, then retighten all wheel nuts and bolts; check them regularly. For correct torque values refer to TECHNICAL DATA. 11.Before working on the electrical system, always remove the ground strap from the battery. Observe the following, when carrying out electric welding.
When carrying out electric welding on tractor or mounted implements, make sure that both battery terminals are disconnected. Attach the ground terminal as close as possible to the welding point. 12.Spare parts must at least meet the technical requirements stated by the manufacturer. You can ensure that this is the case by using genuine spare parts! Text-module ETNum-list ETNum-list 11