Chapter 2 Setup Setting method Do not remove the DIP switch cover until after turning the power off. Removing the cover while the power is turned on may damage the device. 1 Turn off the power of this product and system, and remove cable. 2 Remove the DIP switch cover. DM-D110 DM-D210 ON 1 2 3 4 5 6 7 8 9 10 2 DIP Switch Cover 3 Change each setting of the switches Refer to "DIP Switch 1 Functions" on page 29 for the function of DIP switch. 4 Attach the DIP switch cover, and turn on the power of this product and the system. Setting the DIP Switches (TM-H6000VI) When using TM-H6000VI, see the following settings. • Set DIP switch 2-2 on the printer to "ON".
• Change the settings according to the connection method between the printer and host. ∗ Serial (USB/Ethernet controlled): Set "DM-D Enabled Interfaces" on the printer to "All". ∗ Serial (Y-type): Set "DM-D Enabled Interfaces" on the printer to "Serial I/F Only". 28 12345678910 123456 78910