Downloaded from https://www.everyspec.com ) so that the peripheral load is 0.043W 0.037 x 112,800 = 1080 lb/in FT w =06.46-7R. 0.467 X 8.25 ,s and from Equation 40, the induced bearing * pressure is_ W 1080 _ 198-ps P b =- 198 psi 11 .6 C TR-lI 1.666 OF The pressure is less than the limit stated in , REACTIONS Paragraph 28. Similarly, according to AD,, in Paragraph 70, ___ the bearing pressure induced by the chordal 4 " 9 RAO gusset load is 0.104W 0.104 X 79,500 = Fjgure 28.
Trunnion Loads and Reactions P6= 0.467RL = 0.467 X 8.5 X 5.46 = 382 psi M = 1.66 FT = 116,000 lb-in Although this pressure is greater than that Mc 116,000 x 1.38 for the tangential gussets, it is also less than 2 = = 2.85 = 56,300 lb/in 2 the maximum allowable. B. TRUNNION A S strength of 90,000 lb/in The trunnion is made of steel with a yield 74. The trunnions support the normal and Sf = 90, = 1.60 axial forces during firing plus the couple intro- 56,300 duced by the rifling torque.
From Equation 9 This is a short beam, therefore, the horizontal shear stress may be severe T = 0.61Rk, = 545,000 lb-in, rifling torque F___ N, "T - 15,500 lb/in 2 where 0.6 X 90,000=3.8(tcria) N, = 25 cal/turn, twist of rifling S 1 ,500 3.48 (not critical) P, = 36,000 psi, maximum propellant gas Rb = 4.0 in, radius of bore 2 4 T, t =2.76 in F, - = 19,500 lb, trunnion load due to = 0.56 in d,5i 0.586 in torque 76. The trunnion housing shown in Figure where 19 is a weldment. The principal stresses occur d, = 28 in, span of trunnion bearings in the welds of the gussets and in the joint between hub and cradle body.
Four gussets Tho maximum load on a trunnion bearing is on each housing are parallel to the cradle axis IIF\ ('p \2 and carry components of the axial force FA. FT = ,L)' + (2 + F) = 69,500 lb Four other gussets on each housing are perpen- (see Paragraph 65 for values of FA and Fv.) dicular to the axis and carry components of the normal forces Fit and F,. The analysis of the 75. The trunnion in the hub is shown in former will be shown. Figure 29 shows the Figure 28. Assume triangular distributions isolated gusset with the applied loads. for the reactions in the housing cylinder.
The numerical values of Figure 19 Are Then, according to the dimensions shown a = 4.7 in n = 4, number of gussets c = 3.45 rh = 2.75 -1 =X 2.761 =2.85 in, 64 F,, = 111,800 lb (see Paragraph 65) pressure A 1 X 2.762 = 2.99 in 2 255-012 (8040A) 0 - 67 - 4 31