User Manual EM303B General Purpose Inverter Setting Frequency Hz Setting Frequency Hz F8-08 100% FMAX F8-08 100% FMAX F8-09 F8-09 70% 70% F8-10 40% F8-10 40% F8-11 10V Analog Setting F8-11 Analog Setting (c) (d) Figure7-29 Input/Output Bias F8-16 ～ F8-23 set input/output bias 1, the setting method is the same as that of setting 0.00% 0.00% F8-15 F8-14 F8-13 F8-12 40% 75% 100% 0.00% 0.00% 10V F8-15 F8-14 F8-13 F8-12 40% 75% 100% input/output 0. F8-24 ～ F8-31 set input/output bias 2, the setting method is the same as that of setting input/output 0. 8.11 F9 Group:
Speed Setting Options Data Input 8.11.1 Parameter Editing Mode F9-01=0 Inverter parameters can be set via keypad or RS485 communication F9-01=1 Inverter parameters can be edited and set via keypad. 8.11.2 Data Input Control Mode 137 2V 5.2V 8V 4V 7.5V No. Function Range Unit Default Type Parameter Editing Mode 0:Editable through keypad and RS485 1:Editable through keypad 0 〇 F9-01 No. Function Range Un it Default Type Numeric Input Control Mode Ones place: Numeric reference input control mode 0: Auto-save the change in RAM (Press DATA to save) ENTER 1: Auto-save the change in EEPROM (Memory function at power failure) Tens place: Not used Hundreds place: Not used Thousands place:
Terminal UP/DOWN rate control 0: Automatic rate control 1: Correspond to the setting UP/DOWN rate Ten thousands place: Not Used 1000 〇 F9-02 UP/DOWN Frequency Rate 0.00～100.00/0.0～100.0 Hz/ S 1.00 ● F9-07