User Manual EM303B General Purpose Inverter Table 6-1 Functions of Numeric Multi-function Input Terminals 57 No. Function Range Unit Default Type S/N F2-26 M1Output Upper Limit 0.00～100.00 % 100.00 ● 91 F2-27 M1 Output Gain 0.00～300.00 % 95.00 ● 92 F2-28 Not used ~F2-31 No. Function No.
Function 0 Disabled 26 Not Used RUN-run Switching Speed Input Setting to Primary Speed Setting 1 27 F/R Forward/Reverse Switching Speed Input Setting to Auxiliary Speed Setting 2 28 Preset Speed Terminal 1 Switching Primary Speed Setting to Regular Speed Setting 3 29 Preset Speed Terminal 2 Switching Regular Speed Input Setting to Numeric Speed Input Setting 4 30 Preset Speed Terminal 3 Switching Jog Input Setting to Jog Numeric Speed Input Setting 5 31 6 Preset Speed Terminal 4 32 Not Used 7 Acceleration/Deceleration Time Terminal 1 33 Not Used 8 Acceleration/Deceleration Time Terminal 2 34 Not Used Coast to Stop Switching Regular Torque Input Setting to Numeric Torque Input Setting 9 35 10 Inverter Fault Reset 36 Not Used 11 Forward Jog FJOG 37 PID Positive/Negative Setting Switch 12 Reverse Jog RJOG 38 Not Used 13 Terminal UP 39 Not Used 14 Terminal DOWN 40 Not Used 15 UP/DOWN Clearing 41 Not Used 16 Acceleration/Deceleration Prohibited 42 Not Used 17 Ramp to Stop 43 Not Used 18 3-wire Sequence Stop Control (Pulse Stop) 44 Preset Current Limit Terminal 1 19 Not Used 45 Preset Current Limit Terminal 2 Switching Drive Control Mode to V/F Control Mode Preset Current Limit Terminal 3 20 46 Switching Run Command to Terminal Control Mode Start Wobbulation Operation 21 47 22 Run Command Input 0 48 Not Used 23 Run Command Input 1 49 Program Operation Reset(Reset Time,Pulse) Switching Input Control Mode to Speed Control Mode Alternate Motor Switching Command 24 50 Switching Input Control Mode to Torque Control Mode External Fault Input 25 51