User Manual EM303B General Purpose Inverter 1. When reverse is permitted, inverter will judge present running direction based on the setting of F0-08 and the status of terminal F/R. If F0-08=1 and terminal F/R is on, inverter runs forward. 2. If the setting forward direction of inverter is not identical with the expected running direction of motor, switch any two of output cables (U, V, and W) of inverter or set F0-08=1. F0-26=0 Primary speed setting mode is the regular speed setting mode. Primary numeric speed setting mode or analog signal setting mode can be set by selecting parameter of F0-06. F0-26=1 Primary speed setting mode is the special speed setting mode.
Special speed setting mode can be selected as program running or stepping speed setting mode by advanced running mode. F0-26=2 Primary speed setting mode is process PID input mode. Numeric PID setting mode or analog signal setting mode can be selected via F4-00. F0-27=0 Keypad only displays the basic setting parameters of F0~F5. (6-group parameters could meet the needs of most of applications.) F0-27=1 Keypad displays 17-group parameters of F0~FF for users to set parameters. Reset Default F0-28=1 Reset Default: Except motor parameters in Group F1 Group and FA Group, and inverter parameters in Fd Group, the rest of parameters will reset to default. After reset completed, F0-28=0.
Parameter Lock F0-29=0 All parameters are allowed to be edited. F0-29=1Parameter lock 0 Lock parameters except numeric settings. The numeric settings are primary numeric frequency setting F0-07, auxiliary numeric frequency setting F9-06, jog running frequency 91 No. Function Range Unit Default Type Primary Speed Setting Mode 0: Regular speed setting mode 1: Special speed setting mode 2: Process PID input mode 0 〇 F0-26 No. Function Range Unit Default Type Menu Mode Options 0: Basic menu mode 1: Advanced menu mode 0 〇 F0-27 No. Function Range Unit Default Type Default Control 0: Disabled 1: Defaults Reset 0 〇 F0-28 No. Function Range Unit Default Type Parameter Setting Control 0:
Parameter setting permitted 1: Parameter lock 0 2: Parameter lock 1 0 〇 F0-29