The full-page label layout is shown below. Figure 4.3.2-4 Full-page label layout Table 4.3.2-4 List of full-page label setting values For black mark detection, the command can be set with the value obtained by subtracting the gap between labels from the gap between black marks as the length, using the gap between black marks and gap between labels as user input. Setting a gap between labels of less than 3 mm is not recommended. Refer to the limitations described later for details. Epson ESC/Label Application Development Guide CW-C8000 Series Rev.
B Page 23 Item Setting range Recommended initial value Command Black mark No mark Width [mm] 21.4 to 112.0 21.4 to 112.0 108.0 ^S(CLS,P Length [mm] 8.0 to 1016.0 11.0 to 1016.0 152.4 ^S(CLS,L Gap between labels [mm] 3.0 to 6.0 0.0 to 6.0 Less than 3.0 is not recommended 3.0 ^S(CLS,C Left&Right gap [mm] 0.0 to 6.0 0.0 to 6.0 2.0 ^S(CLS,G ^S(CLS,R