REMOTE CONTROL FEATURES AND SETTINGS Remote Control Features and Settings Remote Control Temp + : Every time the button is pressed, the temperature setting increases. Temp - : Every time the button is pressed, temperature setting decreases. The operating temperature range is 60°F-86°F (16°C-30°C). 5. FAN SPEED Button FAN SPEED: For each press the fan speed changes as follows: Remote control: 7 1 8 6. DRY Button DRY mode is used to reduce humidity. In DRY mode, when room temperature becomes lower than temp. setting +2°F, unit will run intermittently at LOW speed regardless of FAN setting. The 2 6 will be displayed during DRY mode. 3 4 7.
FAN MODE Button FAN mode circulates air only; there is no temperature adjustment available. Use the fan speed button (5) to adjust fan speed from low, medium to high. Auto, Turbo and Quiet are not available. 10 11 9 5 8. TURBO Button The TURBO function is used for fastest air flow in Heating or Cooling modes. Control will display the TURBO icon [UP ARROW] on the bottom right side of the remote display. Pressing the TURBO button again or the FAN SPEED button will turn TURBO off. 14 16 12 15 17 19 9. Quiet Button The QUIET function switches the fan to the lowest speed. The control will display the QUIET icon [DOWN ARROW] on the bottom left side of the remote display.
Pressing the QUIET button again or the FAN SPEED button will turn QUIET off. 13 18 1. Power Button Press the ON/OFF button on the remote control to start or stop the unit. 10. Louver UP/DOWN Button Press the LOUVER UP/DOWN button to choose the position of the horizontal airflow louvers. Status display of air flow 2. COOL Button In COOL mode, the unit operates in cooling. When FAN is set to AUTO, the heat pump automatically adjusts the fan speed according to the room temperature. The COOL/DRY: will be displayed during COOL mode. HEAT: NOTE:
• It is advisable not to keep the vertical louver in the downward position for an extended period of time in COOL or DRY mode, otherwise condensate water may form on the louver. • When turning the unit on, the remote control will automatically return the louver to the previous set swing position. When turning the unit off, the louver will rotate to the full open position prior to closing. 3. HEAT Button In HEAT mode, warm air will blow out after a short period of the time due to cold-air prevention function. When FAN is set to AUTO, the heat pump automatically adjusts the fan speed according to room temperature. The will be displayed during HEAT mode. 4.
Temperature +/- Buttons 4 49-5000277 Rev. 0