Remote Control Features and Settings REMOTE CONTROL FEATURES AND SETTINGS 11. Louver SIDE/SIDE Button (select models) Press the LOUVER SIDE/SIDE button to choose the position of the vertical airflow louvers. Status display of air flow COOL/DRY/HEAT/FAN Press F/C to toggle remote and unit display temperature between Fahrenheit and Celsius. 14. EXTRA FUNCTION Button Press the EXTRA FUNCTION button to view all other operations. Press CONFIRM/CANCEL to select and save the chosen operation. If no button is pressed for 10 seconds, the remote will exit EXTRA FUNCTION mode. A) Refresh air NOTE:
• When humidity levels are high, condensate water may occur at the air outlet if all vertical louvers are adjusted to far left or right. • When turning the unit on, the remote control will automatically return the louver to the previous set position. - Feature not available on this series. B) A-B selection - This will allow you to control two separate units with a single remote control. Note: This feature would be setup at the time of installation by the contractor. C) Auto mode - The heat pump will automatically select Cool, Heat, or Fan operation according to set temperature. When FAN is set to AUTO the heat pump automatically adjusts the fan speed according to room temperature.
D) Upper and Lower louver lock. 12. SLEEP Button 1. Operation in COOL or DRY modes: One hour after SLEEP mode starts, the temperature will rise 2°F above set temperature. After another hour, the temperature rises additional 2°F. The unit will run for additional six hours before it turns off. The final temperature is 4°F higher than initial set temperature. Using this feature helps with achieving maximum efficiency and comfort from your unit while you sleep. 1. Upper louver lock will lock the horizontal louver in the top position. Commonly used during cooling. 2. Lower louver lock will lock the horizontal louver in the lower position. Commonly used during heating. 3.
To unlock the louver press EXTRA FUNCTION button . Note: When the louver is locked, the position cannot be until either a single louver icon or oscillate icon changed with the LOUVER UP/DOWN button. E) Timer ON/OFF: Sets a countdown timer until the unit is turned ON/OFF. TEMP+/TEMP- button is pressed with the length of time increment/decrement in 0.5 hour between 0-12 hours,and 1 hour increment/ decrement between 12-24 hours. 2. Operation in Heat Mode: One hour after SLEEP mode starts, the temperature will decrease 4°F below set temperature. After another hour, the temperature will decrease an additional 4°F. After an additional three hours, the temperature will rise by 2°F.
The unit will run for an additional three hours before it turns off. The final temperature is 6°F lower than the initial set temperature. Using this feature will help with achieving maximum efficiency and comfort from your unit while you sleep. 1. When the remote is set to ON, the system will turn off until the countdown timer ends. Then the indoor unit will turn on and operate in mode, temperature setting and fan speed that was displayed when timer was set. 2. When the remote is set to OFF, the system will remain ON until the countdown timer ends. F) 48°F Heating sets the system to maintain 48°F. This is used to prevent freezing during long unoccupied periods of time. 3.
In AUTO mode, the unit operates in corresponding sleep mode adapted to the automatically selected operation mode. NOTE: • When the unit is set to sleep mode, the fan speed will be set to low speed and cannot be changed. • When the TIMER function is set the sleeping function cannot be set. If the sleeping function has been set and the user sets the TIMER function, the sleeping function will be canceled and the unit will be set to the timer function. 15. Confirm/Cancel Button Saves and exits the EXTRA FUNCTION selection. 16. HEALTH Button Feature is not Available 17. LOCK Button Used to lock buttons and LCD display. 13. Fahrenheit/Celcius Button 49-5000277 Rev. 0 5