3 Tutorial 4 — Using Measurement Tools in an Inspection Advanced Tool Tutorials 71. In the Properties, set the following Pin to Pin Distance tolerance parameters: – Input Datum — Right to Center.Pt-Pt Distance – With Tolerance — 5% Nominal 72. Minimize the Step Tree Editor. 73. Click . On that properties page, observe that the Nominal Distance is set to the output value of the above Pin to Pin Distance, the Tolerance+/- is set to be the value that is 5% of the Nominal Distance. 74. Click . FIGURE 3–31. Setup and Training Complete Getting Started with Visionscape GigE Cameras 3-41