Hengstler 250 Preset Revolution, Length or Stroke Counter Datasheet (EN)

email: sales@impulseautomation.co.uk web: www.impulseautomation.co.uk Preset Revolution, Length Measuring or Stroke Counter Type 250 5-digit display Large 6.5 mm digits Button reset TECHNICAL DATA Display 5-digit display Digit height 6.5 mm Electrical connection rear strain relief 4-wire cable, approx. 30 cm long Protection class IP 40, connections IP 00 (EN 60529) General design EN 61010-1, EN 50178 Protection according to class I Contamination level 2 Over voltage category II Base plate Zinc plated sheet steel Case die-cast metal, black varnish Cap plastic (ABS), grey Weight approx.

800 g Counting mode – + subtracting in specified direction of rotation, adding in reverse, stroke counter – subtracting in specified direction of rotation Transmission ratio see "Order information" Speed 10000 increments/min, stroke counter 800 strokes/min Actuating angle min. 38°, max. 55° (stroke counter only) Torque 1.2 Ncm, stroke counter 8.0 Ncm Reset button reset, secured against accidental operation Output Signal duration on transition from 00000 to 99999 until reset Contact type single-pole changeover contact Switching voltage max. 125 VDC/250 VAC Switching current max.

20 VA/0.3 A Don’t push the reset pushbutton during the process DIMENSIONS Dimensions in mm Information shown in these data sheets are for guidance purposes only, no liability is accepted for any errors or omissions. The designer or user is solely responsible for the safe and proper use of these parts, assemblies or equipment described. Doc No: TTCC250 Rev: 001 Impulse Automation Limited United Kingdom Company Registration 665193 Page 18-11-19 1 of 2

Стр. 1

Technical data Type 250 CONNECTION DIAGRAM blue black brown yellow-green ORDER INFORMATION Actuation Transmis- Display Unit Bz Bw sion ratio Revolution counter Length counter 1:1 99999 0 250 001 0 250 002 2:1 99999 m 0 250 019 0 250 020 1:5 9999.9 m/dm 0 250 023 0 250 024 Stroke counter 1:1 99999 0 250 301 0 250 302 Accessories Stroke lever Ordering code 0 600 005 For other stroke levers, measuring wheels and installation frames see "Accessories" Information shown in these data sheets are for guidance purposes only, no liability is accepted for any errors or omissions. The designer or user is solely responsible for the safe and proper use of these parts, assemblies or equipment described.

Doc No: TTCC250 Rev: 001 Impulse Automation Limited United Kingdom Company Registration 665193 Page 18-11-19 2 of 2

Стр. 2