Chapter 20 Network Configuration and Data Exchange 20.3.3 Communication Parameter Settings (Step 2) After the system leads users to the second step, the users have to set the communication parameters in the PLC Link Table Editor window. The parameters uploaded through the master station are displayed at the left part of the window. The setting of the communication parameters of all the slave stations in the same network must be the same as the setting of the communication parameters of the master station. If no parameters are uploaded, “Unknown” will be shown in the boxes at the left part of the window.
If the station address uploaded is different form the station address assigned o the master station, the Station Address box will become red. 20-43