L-4533A/L-4533AW/L-4033A/L-4033AW Operation Guide Introduction Right side 18 Letter Name Explanation a Touch panel A display for the touch panel system. Only three connectors can be used with this press and they have been connected already. Do not connect cables to any other points. b USB connectors (two positions) USB connectors for a keyboard and mouse. c Operation table A platform for the keyboard and mouse for operating the touch panel. d Rewinder Winds up the printed substrate automatically. e Wind Ready switch Stops or starts automatic winding of the substrate. The lamp for the switch also indicates the following statuses. Lit: Ready to start automatic winding. Off:
Automatic winding is stopped. Flashing: The roll diameter detection lever is raised. If the roll diameter detection lever is lowered, the lamp turns off. f Set Tension switch Adjusts the winding tension for the substrate. g Initial Wind switch Push after replacing the paper core to prepare for initial winding. Slowly winds up the substrate while pushed down.