LVS-7500 External System Installation and Quick Start Guide 3. Connect the External I/O Cable to the printer. 4. If desired, reference the External I/O Wiring Diagram for external I/O wiring instructions. 5. Plug the 24-volt power supply cable into the LTIU (see below). IMPORTANT: The 24-volt power supply is for the Light Tower only. DO NOT connect the 5-volt power supply to the LTIU. DO NOT connect the 24-volt power supply to the LVS-7500 External System readhead. Using the wrong power supply will result in system failure. 6. Plug one end of the AC line cord into the power supply box and the other end into a power outlet. 7.
Plug one end of the USB cable into the USB connector on the LTIU (see below) and the other end into a USB port on the computer. 8. LTIU installation is complete. LVS-7500 External System Installation and Quick Start Guide Page 41 of 45