LVS-7500 External System Installation and Quick Start Guide Step 6: Log onto the LVS-7500 External System Software 1. Log onto the LVS-7500 External System software by double-clicking the “LVS-7500” icon located on the desktop. 2. The following message appears which indicates the Stop Motion Unit is not connected. Click “OK.” To disable the Stop Motion Unit, open the LVS7500.ini file and change the “EncoderPort” setting to “0”. Example: EncoderPort= 0 To enable the Stop Motion Unit, change the “EncoderPort” setting to “-1”. Example: EncoderPort= -1 (default setting) For more information on the LVS7500.ini file, refer to “Appendix A:
LVS7500.ini File” in the “LVS- 7500 External System Operations Manual” (located on the installation flash drive supplied with your system). 3. The “Welcome” screen appears. 4. Click the “Log In” button and enter “admin” (not case sensitive) in the “Operator ID” and “Password” fields. 5. You are now logged in to the LVS-7500 External System software. Refer to the “LVS-7500 External System Operations Manual” located on the installation flash drive for steps on operating the LVS- 7500 External System software. LVS-7500 External System Installation and Quick Start Guide Page 42 of 45