Connection Procedure for Remote Access 22 Startup Guide – Remote Access - RT1 Series - P151-E1-02 4 Connect DEV1 port and DEV2 port on SiteManager to Port 1 on Controller and Ethernet port on Personal computer with Ethernet cables, respectively. For (2), 1) LAN connection insert the SIM card for 3G/4G For (2) and (3), communication into SIM card slot. Connect UPLINK port and the connect the 3G/4G antenna internet router with an or WiFi antenna to Connector for antenna. Ethernet cable. 2) 3G/4G connection Connect the 3G/4G antenna to Connector for antenna, and Ethernet cable Connect Personal computer to DEV2 insert the SIM card for 3G/4G For (1), port.
connect UPLINK port communication into SIM card to the internet router. Ethernet cable slot. Ethernet cable Power supply 3) WiFi connection Connect the WiFi antenna to Power supply Connect Controller Connector for antenna, and to DEV1 port. check that the WiFi access point is enabled. Depending on the model only one DEV port (DEV1) Connect Power supply to might be provided. Connect Personal computer to DEV1 port during the SiteManager setup. Controller. After completing the setup, disconnect Personal computer, and then connect Controller to DEV1 port.
*For information on the power supply connection to Controller, refer to 5-4-1 Wiring the Unit Power Supply of the NX-series NX102 CPU Unit Hardware User's Manual (Cat. No. W593).