Clock and timers Setting the clock This is a 12-hour clock. 1 Press [SETUP] repeatedly to select “CLOCK”. 2 Press [ R , T ] to set the time and then press [OK]. To check the time Press [SETUP] repeatedly to select “CLOCK” and then press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Play timer (Except for Bluetooth ® source) You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] repeatedly to select “TIMER ADJ”. 2 Press [ R , T ] to set the start time and then press [OK]. 3 Do step 2 again to set the end time. 4 Press [ R , T ] to select the source you want to play and then press [OK].
To start the timer 1 Prepare the source you want to listen to (disc, USB or radio) and set the volume. 2 Press [SETUP] repeatedly to select “TIMER SET”. 3 Press [ R , T ] to select “SET” and then press [OK]. # ” is shown. To cancel, select “OFF”. The system must be turned off for the timer to operate. To check the setting Press [SETUP] repeatedly to select “TIMER ADJ” and then press [OK]. In standby mode, press [DISPLAY] two times. Note: The timer starts at a low volume and increases gradually to the preset level. The timer comes on at the set time every day if the timer is on.
If you turn off the system and then turn on again while a timer is in operation, the timer will not stop at the end time. TQBM0945 19