PanelScan Integration Guide Trigger Mounting A reflectance trigger is provided that will trigger one or two cameras when the board passes under them. The trigger must be mounted so that it sees the leading edge of the board just before it passes under the camera. The trigger should be mounted approximately 50 mm up from the board looking down, and 25 mm in front of the leading edge. The trigger should not block the light from illuminating the board. Place the trigger near the edge of the board to ensure that no holes in the board pass beneath the trigger. PC Requirements The user must supply the PC for PanelScan operation. The following are the basic PC specifications required by the system.
• Modern Multicore PC • Windows 7 64-Bit • 6-8 GB of RAM • Intel chipset-based NIC card, one channel for Standard and two channels for Wide. • C-States should be turned off for optimum GigE performance. The option to disable C-States appears during AutoVISION installation. • All other sleep and hibernate states should be disabled so the PC always operates at full power and capacity. • Monitor Resolution of 1280 x 1024 Required Software PanelScan requires that the four software elements shown below be installed before operation. All the required software is supplied on the USB drive that is included with the PanelScan kit:
• Pylon 5 Camera Software Suite 5.0.5.8999 in the BaslerPylonInstall folder; • AutoVISION 4.0.3 in the AutoVISION folder; • PanelScan 1.5.1 in the PanelScanInstall folder. Note: The USB drive also contains: • Microsoft .NET Framework client installer in the DotNetFX40Client folder; • A Windows Update package in the WindowsInstaller3_1 folder. These only need to be installed if they are not already present on the host PC. 8 Copyright © 2019 Omron Microscan Systems, Inc.