Руководство по эксплуатации Phoenix Nano — Настройка и использование (EN)

Quick User Guide EN FR ES DE IT PT RU TC 日本語 Guide de dйmarrage rapide Guнa de Inicio Rбpido Schnellstart-Anleitung Guida Rapida Phoenix Nano Guia de Inнcio Rбpido Краткое руководство クイックスタートガイド 快速入門

Стр. 2

EN IMPORTANT: Read the instructions carefully and use the unit properly before operating according to the guide. Failure to do so may cause damage and/or personal injury and will void the product warranty. 1. Charging & Turning On 1. Use the included power adaptor to charge the tablet. 2. After charging is complete, press the POWER button to turn the tablet on. The system starts initializing and then enters the home screen. Warning: Please use the included power adaptor to charge your tool. No responsibility can be assumed for any damage or loss caused as a result of using power adaptors other than the one supplied. 2. Language Setting The tool supports multiple system languages.

Follow the steps below to proceed language settings: 1. On the home screen, tap “Settings” -> “System” -> “Language & 2. Tap “Add a language”, and then choose the desired language from input” -> “Languages”. 3. Tap and hold the desired language and drag it to the top of the the list. screen and then release it. The system will change into the target language. 3. WLAN Setup After connecting online, you can register your tool, update the diagnostic software and APK, and browse the Internet, among other functions. Follow the steps below to proceed: 1. On the home screen, tap “Settings” -> “Network & internet” -> “Wi-Fi”. 2. The tablet will start searching for all available wireless networks.

Select the desired Wi-Fi connection from the list (password may be required for secured networks). 3. When Connected appears, it indicates that it is properly connected to the network. 4. Register & Update New users must complete a sign-up process to register and update. Follow the steps below to proceed: 1). Launch app: Tap the application icon on the home screen, and then 1

Стр. 3

tap “Login” on the upper right corner of the screen. The following screen will appear. 2). Create an App Account: Tap “New Registration”, input the information and then tap “Register”. 3). Activate VCI: Input the 12-digit Product Serial Number and 8-digit Activation Code (can be obtained from the password envelope), and then tap “ACTIVATE.” 4). Complete Registration: Tap “OK” to access the update center and update all available software. 2

Стр. 4

EN All software is updated periodically. It is recommended to check regularly for updates and install the latest software version for the best service, functions and experience. *Note: Make sure the Wi-Fi connection is strong and stable while upgrading. 5. Preparation • The ignition is turned off. • The vehicle battery voltage is 9-18V. • Locate the vehicle Data Link Connector (DLC) port. For Passenger Vehicles, the DLC is usually located 12 inches from the center of the instrument panel, under or around the driver’s side for most vehicles. For some vehicles with special designs, the DLC location may vary. Refer to the following figure for location.

If the DLC cannot be found, refer to the vehicle’s service manual for the location. • Use the included diagnostic cable to connect the diagnostic tablet to the vehicle’s DLC port. • Switch the ignition key to the ON position. 3

Стр. 5