3.2 Rear Panel Connectors and Features 3.2 12 EM2100 Installation Guide 20569-000 Rev. A Callout Label Port Description information. 4 SYS n/a System status indicator LED. Indicates the power state of the EM2100 appliance (lit when the appliance is powered ON). 5 HDD n/a Internal storage activity indicator LED. Lit while the internal hard drive disk is busy (read / write activity). 6 MAINT ETH0 Maintenance Ethernet network port. The Maintenance port is always enabled and is not password pro- tected. Use this port for initial setup, troubleshooting, and as an alternate method of access. This port has a fixed IP address of 1.2.3.4. 7 MGMT ETH1 Management Ethernet network port.
The SetNetGo access Ethernet port (AMRs cannot access this Eth- ernet port). 8 FLEET ETH2 Fleet Ethernet network port. The port for AMR and MobilePlanner operational network con- nections. 9 SYNC ETH3 Synchronization Ethernet network port. Reserved for future use. 10 KEY n/a Front USB port Service use only. Additional Information: Contact your system administrator for assistance con- figuring the EM2100 appliance for your network. Refer to Site Networking Requirements on page 17 for more information. ear Panel Connectors and Features This section describes the connectors, indicators, and physical characteristics of the EM2100 appliance rear panel. Figure 3-2.
EM2100 Rear Panel Connectors and Features