6.2 Access SetNetGo on the EM2100 AMR. Once connected, ensure "SETNETGO - FLEET MANAGER 2100" is present at the top of the interface to confirm connection with the appliance. Additional Information : Review the Fleet Operations Workspace Core User's Guide for more information about SetNetGo settings and configuration. Access SetNetGo with a Web Browser Use the following procedure to access SetNetGo with a web browser. NOTE: After connecting a CAT 5 Ethernet cable from the client PC to the MAINT ETH0 port on the appliance, use the procedure in Set the IP Address the Client PC's Network Adapter on page 33 before following the procedure below. 1. Open a web browser and access https://1.2.3.4.
2. If a certificate warning dialog opens, ignore it and close the dialog. 3. The following view should appear to indicate a successful connection. Figure 6-1. Initial SetNetGo Web Browser Display Additional Information : After establishing a connection to the EM2100 with the procedure above, the appliance is ready to be configured for operation with a AMR fleet. Refer to the Fleet Operations Workspace Core User's Guide for more information. Access SetNetGo with MobilePlanner Use the following procedure to access SetNetGo with MobilePlanner. Additional Information : This process may also be used for the initial EM2100 configuration. 34 EM2100 Installation Guide 20569-000 Rev. A