Chapter 6: Connecting to the EM2100 1. Start the MobilePlanner software on your PC. 2. Enter the IP address of the appliance into the area shown below (example IP shown in the figure below may not be the IP assigned to your appliance). Figure 6-2. Enter the IP Address of the Appliance 3. Click anywhere in the SetNetGo selection box to access the SetNetGo interface. Figure 6-3. Access SetNetGo with MobilePlanner Software NOTE: It is not necessary to enable (check) the checkbox within the SetNetGo selection box. The checkbox determines whether SetNetGo starts automatically when you open MobilePlanner. 4.
If prompted, enter valid Fleet account credentials to access the SetNetGo view (refer to the Fleet Operations Workspace Core User's Guide for more information). Additional Information : After establishing a connection to the EM2100 with the procedure above, the appliance is ready to be configured for operation with a AMR fleet. Refer to the Fleet Operations Workspace Core User's Guide for more information. 20569-000 Rev. A EM2100 Installation Guide 35