.'H Vl. INSTALLING THE PULLEY GUARDS Parts required -- 2 ea Pulley Guards Loosen the 1/4-20 x 1-1/4 inch pan head screw located at the top of each corner of the frame assembly. Remove the 1/4-20 x 1/2 inch pan head screw and 1/4-20 Hex nut from the top of each corner of the frame assembly. Place the pulley cover over the pulley and align the slot at the front of the guard with the 1-1/4 inch pan head screw and re-install the 1/2 inch pan head screw through the holes in the side of the guard. then through the Corner Track Brackets. Tighten= the four pan head screws. Repeat the pulley guard installation with the remaining guard.
Run the pulley and yoke assembly back and forth to make sure that the pulleys do not drag on the inside of the covers. It may be necessary to loosen the screws and shift the covers slightly to clear the pulleys. / LOOSEN VII. MOUNTING YOUR ROUTER RECREATOR TO A STAND To insure safe accurate operation it is important that the frame of your Router Recreator is fastened to a suitable table or leg set. if you fashion your own leg set, remember to provide access to center of the unit and sufficient clearance of the corner brackets for the positioning of the shelf boards. FRONT STIFFENER NOTE: The recommended ieg set for the router recreator is catalog no. 9-22238. NOTE:
See page 2 & 3 of instructions for catalog no. 9-22238 leg set and assemble the legs according to trle section headed "For Bases Measuring 24" x 27"." IMPORTANT: You must attach the side stiffeners to the outside faces of the legs as shown m this illustration. ATTACH SIDE STIFFENERS TO OUTSIDE FACES OF THE LEG 12