alignment ALIGNING YOUR ROUTER RECREATOR Proper alignment of your Router Recreator is essential for accurate results. Although your Recreator is designed to maintain its' alignment, it is suggested that you check the pulley tracking and Router/Stylus alignment not only before beginning a project, but'occasionally during the project itself. Remove the two Stylus Rods from the ioose parts bag, Place the 1/4 inch end of one of the Stylus Rods in the chuck of the router, Snug the Stylus in place with the Router Chuck Wrench (supplied with Router). Place the second Stylus in the Stylus Mount. This is done by backing off on the small black knob and then re-tightening when the stytus is in place.
@ @ Loosen the two Tilt Plate wing nuts which will allow the Stylus/Router Mount to pivot. Roll the Yoke Assembly forward on the Tracks and position the Stylus located in the Routerchuck flush against the front face of front Shelf Board with the chuck face resting on the edge of the shelf. Tighten both Tilt Plate wing nuts. t3