Place the threaded end of one cable through the small hole in the tab at the front end of the pulley track as shown. Wrap the cable one time around the pulley and then push it through the hole in the tab at the rear of the track. While applying slight tension on the cable, with the aid of pliers, install the 3/8 inch washer followed by the 8-32 Hex Nut on the threaded end of the cable as shown. Repeat the cable installation on the other pulley. Check for free movement of the pulleys. The pulleys should not sJide on the tracks but roll freely without any cable slippage.
If additional cable tension is needed, tighten the 8/32 Hex nut securing the cable at the rear, while holding the body of the threaded end with a pliers. NOTE: The tension on the two cables should be about equal. Check the tension on each by "picking" the cable like a guitar string and listening to the sound. Adjust the tension to make the two sounds similar in pitch. iV. INSTALLING THE ROUTER (not supplied) Step four requires the following: E ITEM DESCRIPTION QTY. A Router (motor assembly) .............. 1 B Router clamp , ........................ 1 C 1/4-20 x 1-1/4 pan head screws ........ 4 D 1/4-20 x t-1/2 round head screws ...... 1 E 1/4-20 Hex nut . .......................
1 Your Router Recreator is designed to accept most routers with a motor body from 3 inches to 3-3/4 inches in diameter. If your router does not easily adapt to the router mount, it is not recommended that you attempt any alteration of the mount or your router.