de the Pulley shaft through the bearings at the .rear of the Y0ke Assembly followed by the shaft Collars _ one or1 each side of the Yoke as shown, install 1/4 inchsetsCrew in thethreaded h01e in each of the Collars. The Collars should not be at this time. SHAFT SHOULD EXTEND BEYOND PULLEYS APPROXIMATELY 1/8" Slide the 5 inch Track Pulleys o n to the Pulley Shaft with the hub of the pulley (area which contains the setscrew) facing toward the Yoke as shown. This Shaft shoulc_ extend beyond the Pulleys approximately 1/8 inch on each end. PULLEY HUB / / Place the pulley hubs on the Shaft such that one pulley set screw faces front while the other faces rear as Shown. This wil!
help insure access to one of the set screws during future adjustments. ON EACH END PlaCe the entire yoke assembly on the frame with the pulleys riding on the Track Brackets and the large black Knob facing the front. Loosen the pulley setscrews and push outward on the pulley so that the tracks are riding on the inside corners of the pulley grooves as shown. Tighten the pulley setscrews. The Pulley Shaft should extend beyond the faces of the pulleysan equal amount on each side, TRACK MUST RIDE ON INSIDE EDGE OF PULLEY GROOVE A Iii. CABLE ASSEMBLIES For step three you'll need -- 0))))))l)))})})-- ITEM DESCRIPTION QTY: A Steel Cables ..........................
2 B 8-32 Hex Nuts ..................... 2 C 3/t6 X 3/8 Flat Washers ............... 2