l!. YOKE ASSEMBLY D Step two will require the following parts: ITEM DESCRJPT|ON QTY, A 5" Pulleys ............................. 2 B Pulley Shaft Collars ................... 2 C Socket Head Setscrews, I/4-20 x t/4" .. 2 D Pulley Shaft ........................... 1 E Yoke Sub-Assembly ................... 1 F Counterweight Shaft ................... 1 G Pan Head Screws, 10-32 x 3/4" . ........ 2 H Stylus Mount .......................... 1 J Large Knob ........................... 1 K Small Knob ........................... ! L Socket Head Setscrew, 5/16-18 x t/4" ..
1 YOKE ASSEMBLY Place the Counterweight Shaft inside the rear of the Yoke with the bent section of the Shaft extending out and upward. The two holes in the Shaft should align with the two small holes in the Yoke as shown. Secure it with the two 3/4 inch pan head screws, / ROUTER MOUNT COUNTER WEIGHT SHAFT YOKE BEARING STYLUS MOUNT Screw the large and small Knobs and a 1/4 inch setscrew into the Stylus Mount as shown. Slide this assembly on to the Router Mount Shaft as shown and lightly tighten the setscrew. STYLUS MOUNT SETSCREW