Connecting the Printer The TM-P60II has dual interfaces: a built-in USB interface and another interface selected by the customer, wire- less LAN or Bluetooth interface. See the corresponding section for the interface you selected. • Wi-Fi models: "USB Interface" on page 36 or "Wireless LAN Interface" on page 37 • Bluetooth models: "USB Interface" on page 36 or "Bluetooth Interface" on page 38 • Before connecting the printer, confirm the current interface mode. The printer is initially set to the Automatic selection mode. To change the interface mode, see "Software Settings" on page 42 . • Automatic selection:
When the USB cable is connected with a host PC, the USB interface is preferentially selected. Otherwise, the wireless LAN/ Bluetooth interface is selected. Once the interface is selected, the selection is enabled until the power is turned off or the USB cable is disconnected. USB Interface When communicating with a host PC via the USB cable, connect the USB cable to the printer, turn on the PC, and then turn on the printer. For Windows, you can change the printer settings with the TM-P60II Utility. For details on the TM-P60II Utility, see "Software Settings" on page 42 . • Putting the USB cable through the wire saddle prevents the cable from coming unplugged.
• Do not place any weight or stress on the cable when using. Doing so could damage the cable and connectors. 1 Attach the enclosed wire saddle to the printer as shown in the picture below. 2 Put the USB cable through the wire saddle. Wire saddle 3 Connect the USB cable from the host computer to the USB connector. 4 Connect the other end of the interface cable to the host computer. 36