Appendix A Product Specifications Cut Sheet • Use of check paper, OCR paper, or other fine paper is recommended. Use of some paper types Printable area 3.7 ± 2 mm 72.2 mm 79.5 ± 0.5 mm 101 Paper type Check paper (ANSI standard), plain paper (only one sheet can be used) Size (H × W) 60 to 120 mm × 110 to 235 mm Paper thickness 0.075 to 0.2 mm Paper weight 60 to 120 g/m2 may result in double-feeding by the ASF or other paper feeding problems. It can also lower the capacity of the pocket. • Use flat paper that is not curled or bent (especially the leading edge), curved, wrinkled, or other problems. Paper that is not flat can jam.
• Do not insert paper that has clips, staples, or any foreign objects affixed. Doing so can cause pape r jams, MICR reading problems, damage to the MICR head or scanner head, and other problems. • Since the paper sensor is a reflective sensor, do not use paper that has holes, that is transparency , or that has any areas with reflectance less than 40% in the position shown in the illustration below. However, fanfold paper guide holes with a diameter of 6 mm or less are not detected by the sen- sor. Area where holes are not allowed and paper reflectance is no less than 40% Diameter: 6 mm maximum 55 mm 20 mm Printable Area Roll Paper 20 mm