2. PRINTER SETUP ENGLISH VERSION EO1-33097 2.7 Loading the Media 2.7 Loading the Media (Cont.) 4. Check and adjust the media sensor position and select the sensor type to be used. (Refer to Section 2.8.1 .) This printer has a Black Mark Sensor which can detect black marks printed on the reverse side of the media, and a Feed Gap Sensor which detects inter-label gaps. As the Feed Gap Sensor position is fixed, it is not necessary to adjust it. When using the Black Mark Sensor, align it with the centre of the black mark on the media. Failure to do this will disable the detection of printed black marks, resulting in an error. NOTES: 1.
The sensor type used in the last print job is selected by default. To change the sensor type, refer to Section 2.8.1 Media Sensor Calibration . 2. The Feed Gap Sensor is positioned 6.35 mm right from the media centre. 3. The Black Mark Sensor is movable over the range of the media width. Feed Gap Sensor 6.35mm Black Mark Sensor Black Mark Sensor is movable in the full range. NOTE : Be careful not to squeeze the media with the Media Guides. Doing so bends the media, which can cause a paper jam or feed failure. E2-10