Toshiba B-FV4D SERIES Barcode Printer User & Service Manual PDF (EN)

CE Compliance (for EU only) This product complies with the requirements of EMC and Low Voltage Directives including their amendments. CE marking is the responsibility of TOSHIBA TEC GERMANY IMAGING SYSTEMS GmbH, Carl-Schurz-Str. 7, 41460 Neuss, Germany. For a copy of the related CE Declaration of Conformity, please contact your dealer or TOSHIBA TEC. This product is designed for commercial usage and is not consumer product. This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

FCC Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. (for USA only) CAN ICES-3 (A) / NMB-3 (A) This Class A digital apparatus complies with Canadian ICES-003. (for CANADA only) The EA1050B-240 AC adapter should be exclusively used for the B-FV4D-xxxx-QM-R Series printer. The B-FV4D-xxxx-QM-R Series printer must be powered by the EA1050B-240 AC adapter. The EA10681P-240 AC adapter should be exclusively used for the B-FV4D-xxxx-QQ-R Series printer. The B-FV4D-xxxx-QQ-R Series printer must be powered by the EA10681P-240 AC adapter. California Proposition 65 Warning:

USA-California only This Product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm. The following information is for EU-member states only: Disposal of products (based on EU-Directive 2002/96/EC, Directive on Waste electrical and electronic equipment – WEEE) The use of the symbol indicates that this product may not be disposed as unsorted municipal waste and has to be collected separately. Integrated batteries and accumulators can be disposed of with the product. They will be separated at the recycling centers. The black bar indicates that the product was placed on the market after August 13, 2005.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environmental and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about the take-back and recycling of this product, please contact your supplier where you purchased this product. Notification (for Turkey) AEEE Yцnetmeliğine Uygundur Following information is only for India: The use of the symbol indicates that this product may not be treated as household waste.

By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about the take-back and recycling of this product, please contact your supplier where you purchased the product. This product complies with the “India E-waste Rule 2011” and prohibits use of lead, mercury, hexavalent chromium, polybrominated biphenyls or polybrominated diphenyl ethers in concentrations exceeding 0.1% by weight and 0.01% by weight for cadmium, except for the exemption set in Schedule II of the Rule.

Стр. 2

Precautions for the handling of Wireless Communication Devices This product is classified as “wireless equipment for stations of low-power data transmissions systems” under the Wireless Telegraphy Act, and does not require a radio transmission license. The law prohibits modification of the interior of this product. Regulatory Information This product must be installed and used in strict accordance with the manufacturer’s instructions as described in the user documentation that comes with the product. This device complies with the following radio frequency and safety standards. Standards below are certified under the operation with the provided antenna.

Do not use this product with other antennas. Europe - EU Declaration of Conformity Hereby, TOSHIBA TEC, declares that B-FV4D / B-FV4T series are in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. USA-Federal Communications Commission (FCC) NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. RF EXPOSURE WARNING: This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.

Canada - Industry Canada (IC) This device complies with Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada exemptes de licence RSS standard(s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas causer d'interfйrence et (2) cet appareil doit accepter toute interfйrence, notamment les interfйrences qui peuvent affecter son fonctionnement.

Radio Frequency (RF) Exposure Information The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. This device has also been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions. (antennas are greater than 20cm from a person's body).

Стр. 3

Informations concernant l'exposition aux frйquences radio (RF) La puissance de sortie йmise par l’appareil de sans fil est infйrieure а la limite d'exposition aux frйquences radio d'Industry Canada (IC). Utilisez l’appareil de sans fil de faзon а minimiser les contacts humains lors du fonctionnement normal. Ce pйriphйrique a йgalement йtй йvaluй et dйmontrй conforme aux limites d'exposition aux RF d'IC dans des conditions d'exposition а des appareils mobiles (antennes sont supйrieures а 20 cm а partir du corps d'une personne). Approved Countries/Regions for use for the devices This equipment is approved to the radio standard by the specific countries/regions.

Please ask TOSHIBA TEC authorized dealer or service engineer. Precaution for Use This product communicates with other devices by radio. Depending on the installation location, orientation, environment, etc., its communication performance may deteriorate or devices installed near by may be affected. Bluetooth® and Wireless LAN devices operate within the same radio frequency range and may interfere with one another. If you use Bluetooth® and Wireless LAN devices simultaneously, you may occasionally experience a less than optimal network performance or even lose your network connection. If you should experience any such problem, immediately turn off your Bluetooth® or Wireless LAN device.

Keep away from a microwave. Communication performance may deteriorate or a communication error may occur due to the radio emitted from a microwave. Do not use the product on a metal table or near a metal object. Communication performance may be deteriorated. * Bluetooth® is a registered trademark owned by Bluetooth SIG, Inc.

Стр. 4

Safety Precautions ENGLISH VERSION ( i ) Safety Summary Personal safety in handling or maintaining the equipment is extremely important. Warnings and Cautions necessary for safe handling are included in this manual. All warnings and cautions contained in this manual should be read and understood before handling or maintaining the equipment. Do not attempt to effect repairs or modifications to this equipment. If a fault occurs that cannot be rectified using the procedures described in this manual, turn off the power, unplug the machine, and then contact your authorised TOSHIBA TEC CORPORATION representative for assistance.

Meanings of Each Symbol This symbol indicates a potentially hazardous situation which, if not avoided, could WARNING result in death, serious injury, or serious damage, or fire in the equipment or surrounding objects. This symbol indicates a potentially hazardous situation which, if not avoided, may result CAUTION in minor or moderate injury, partial damage to the equipment or surrounding objects, or loss of data. This symbol indicates prohibited actions (prohibited items). PROHIBITED Specific prohibited contents are drawn inside or near the symbol. (The symbol on the left indicates “no disassembling”.) This symbol indicates actions which must be performed.

MUST be Specific instructions are drawn inside or near the  symbol. Performed (The symbol on the left indicates “disconnect the power cord plug from the outlet”.) NOTE: Indicates information to which you should pay attention when operating the manual. WARNING This indicates that there is the risk of death or serious injury if the machine is improperly handled contrary to this indication. Do not plug in or unplug the power Prohibited cord with wet hands as this may cause electric shock. If the machine share the same Prohibited electrical outlet with any other appliance that consumes a large amount of power, the voltage will fluctuate widely each time these appliances operate.

Be sure to provide an exclusive outlet for the machine as this may cause fire or electric shock. Do not place metal objects or water- Prohibited filled containers such as flower vases, flower pots or mugs, etc. on top of the machine. If metal objects or spilled liquid enter the machine, this may cause fire or electric shock. Do not insert or drop metal, Prohibited flammable or other foreign objects into the machine through the ventilation slits, as this may cause fire or electric shock. Do not scratch, damage or modify the Prohibited power cords. Also, do not place heavy objects on, pull on, or excessively bend the power cords, as this may cause fire or electrical shock.

If the machine is dropped or their Disconnect cabinet damaged, first turn off the the plug. power switch and disconnect the power cord plug from the outlet, and then contact your authorised TOSHIBA TEC CORPORATION representative for assistance. Continued use of the machine in that condition may cause fire or electric shock. Continued use of the machine in an Disconnect the plug. abnormal condition such as when the machine is producing smoke or strange smells may cause fire or electric shock. In these cases, immediately turn off the power switches and disconnect the power cord plug from the outlet. Then, contact your authorised TOSHIBA TEC CORPORATION representative for assistance.

Стр. 5