2. PRINTER SETUP ENGLISH VERSION EO1-33097 2.7 Loading the Media 2.7 Loading the Media (Cont.) Cut mode (Option): When a Cutter is fitted, the media can be automatically cut. When loading the media as described on the previous pages, insert the leading edge of the media through the Media Outlet of the Cutter Cover while pulling the media through the printer. WARNING! HAZARDOUS MOVING PARTS KEEP FINGERS AND OTHER BODY PARTS AWAY The cutter is sharp, so care must be taken not to injure yourself when handling the cutter. Cutter Cover CAUTION! 1. Be sure to cut only the backing paper of the label.
Cutting labels will cause glue to stick to the cutter blades which may affect the cutter quality and shorten the cutter life. 2. Use of tag paper which thickness exceeds the maximum specified value may affect the cutter life. Media Outlet How to Load Fanfold Paper Stock 1. Place the fanfold paper stock at the rear of the printer, insert the leading edge of the paper into the Fanfold Paper Slot. NOTE : When placing fanfold paper stock at the rear of the printer, care should be taken of the following points. 1. Face the print surface up. 2. The fanfold paper stock is parallel to the fanfold paper slot. 3. The interface and power cables do not interfere with the feeding of the fanfold paper.
Fanfold Paper Stock 2. Refer to the previous pages to feed the fanfold paper through the printer until it extends past the media outlet. Fanfold Paper Slot E2-13