2. PRINTER SETUP ENGLISH VERSION EO1-33097 2.7 Loading the Media 2.7 Loading the Media (Cont.) Strip mode (Option): When printing in strip mode, labels are automatically removed from the backing paper as each label is printed. How to set the media When issuing labels in the strip mode, set the label in the following procedure: 1. Load the media as described on the previous pages. 2. Open the Peel-off Unit by pulling it out. 3. Remove enough labels from the leading edge of the media to leave 20 cm of backing paper free, and insert the top edge of the backing paper into the media slot in the Peel-off Unit as shown below. 4. Close the Peel-off Unit and Top Cover. NOTES : 1.
When printing labels without removing them from the backing paper, it is not necessary to pass the media through the Strip Block. 2. When the media is correctly set, the backing paper should be pinched between the Platen and the Strip Feed Roller as shown below. Strip Plate Label Strip Feed Roller Platen Backing Paper Peel-off Unit CAUTION! When opening the Peel-off Unit for loading the media, be careful not to drop metal or other foreign objects, such as a paper clip into the module, as this may cause a malfunction of the printer. E2-12