DPF Regeneration This function is mainly used for the regeneration of diesel particulate filters. To keep the filters performing well it removes particles by means of combustion and oxidation. ABS (ABS Bleeding) When the brake system is opened to replace components such as brake pump, master cylinder, brake lines or brake fluid, air gets inside, which can lead to a soft brake pedal. ABS Bleeding is required to restore the brake pedal's firmness. BMS (BMS Reset) After the car battery is replaced, the car battery control unit needs to be reset.
This will clear fault information (such as low battery level) so that the control unit can match the relevant information of the newly replaced battery. Injector (Injector Coding) After replacing injectors, various codes need to be written to correspond to the code of each cylinder injector. This controls the quantity of oil injection into each cylinder. TPMS (TPMS Reset) After the tire has been reinflated or replaced, the tire pressure information needs to be reset via the tire pressure reset function to resolve the tire pressure fault code.
Airbag (Airbag Reset) This function allows you to reset the airbag data to turn off the airbag light, so that the airbag control module can run normally. It needs to be performed in the following cases: • When the airbag deploys; • When the diagnostic tool reads "Crash data stored"; • When the airbag light is on; • When relevant DTCs cannot be cleared. Sunroof (Sunroof Initialization) This function can turn the sunroof lock off, auto-close in case of rain, set the memory function of sliding/tilting sunroof, set outside temperature threshold, etc. Seats (Seat Calibration) This function can match the seats that are replaced and repaired with memory function. Windows (Windows Calibration) 32