4-4 Communication Function 4 Functions *1. When either the control circuit terminal block or the coil is turned on, these settings are ON. The control circuit terminal block has the priority for the multi-function input terminals. If the master cannot reset the coil ON status because of communication disconnection, turn the control circuit terminal block from ON to OFF to turn off the coil. *2. The communications error is retained until a fault reset is input. (Can be reset during operation.) 4-166 Coil No. Item R/W Description 0014h FA1 (constant speed arrival signal) R 1: ON 0: OFF 0015h FA2 (over set frequency arrival signal) R 1: ON 0: OFF 0016h OL (overload warning) R 1: ON 0:
OFF 0017h OD (excessive PID deviation) R 1: ON 0: OFF 0018h AL (alarm signal) R 1: ON 0: OFF 0019h FA3 (set-frequency-only arrival signal) R 1: ON 0: OFF 001Ah OTQ (overtorque) R 1: ON 0: OFF 001Bh IP (during momentary power interruption) R 1: ON 0: OFF 001Ch UV (during undervoltage) R 1: ON 0: OFF 001Dh TRQ (during torque limit) R 1: ON 0: OFF 001Eh RNT (RUN time exceeded) R 1: ON 0: OFF 001Fh ONT (ON time exceeded) R 1: ON 0: OFF 0020h THM (thermal warning) R 1: ON 0: OFF 0021h Not used 0022h Not used 0023h Not used 0024h Not used 0025h Not used 0026h BRK (brake release) R 1: ON 0: OFF 0027h BER (brake error) R 1: ON 0: OFF 0028h ZS (0 Hz signal) R 1: ON 0:
OFF 0029h DSE (excessive speed deviation) R 1: ON 0: OFF