VLT ® 2900 Series operation. If Active Setup [5] is selected, the program- ming Setup will be equal to parameter 004 Active Setup . Factory Setup (FACTORY SETUP) [0] NB! If data is modified or copied to the active Setup, the modifications have an immedi- ate effect on the unit's operation. Setup 1 (setup 1) [1] Setup 2 (setup 2) [2] Setup 3 (setup 3) [3] Setup 4 (setup 4) [4] Multi Setup (MULTI SETUP) [5] The active parameter Setup is selected here. All pa- rameters can be programmed in four individual pa- rameter Setups. Shifts between Setups can be made in this parameter via a digital input or via serial com- munication.
No copying (NO COPY) [0] Copy to Setup 1 from # (COPY TO SETUP 1) [1] Copy to Setup 2 from # (COPY TO SETUP 2) [2] Factory Setup [0] contains the factory-set parameter values. Setup 1-4 [1]-[4] are four individual Setups which can be selected as required. Multi Setup [5] is used where remote-controlled shifts between the four Setups via a digital input or via serial communication is required. Copy to Setup 3 from # (COPY TO SETUP 3) [3] Copy to Setup 4 from # (COPY TO SETUP 4) [4] Copy to all Setups from # (copy to all) [5] You can copy from the selected active Setup in pa- rameter 005 Programming setup to the selected Setup or Setups in this parameter. NB!
Copying is only possible in Stop (motor stopped in connection with a stop com- mand). Factory Setup (FACTORY SETUP) [0] Setup 1 (setup 1) [1] Setup 2 (setup 2) [2] Setup 3 (setup 3) [3] Setup 4 (setup 4) [4] Copying begins when the required copying function has been selected and the [OK]/[CHANGE DATA] key has been pushed. The display indicates when copying is in progress. Active Setup (ACTIVE SETUP) [5] You can select which Setup you want to programme during operation (applies both via the control panel and the serial communication port). It is, for example, possible to programme Setup 2 [2], while the active Setup is set to Setup 1 [1] in parameter 004 Active Setup .
No copying (NO COPY) [0] Upload all parameters (UPL. ALL PAR.) [1] Factory Setup [0] contains the factory-set data and can be used as a source of data if the other Setups are to be reset to a known status. Setup 1-4 [1]-[4] are indi- vidual Setups that can be programmed freely during Download all parameters (DWNL. ALL PAR.) [2] Download size-independent parameters (DWNL.OUTPIND.PAR.) [3] = factory setting, () = display text, [] = value for use in communication via serial communication port 12 MG.29.A3.02 - VLT ® is a registered Danfoss trademark 004 Active Setup (active Setup) Value: 006 Setup copying (SETUP COPY) Value: Function: Description of choice: Function:
005 Programming Setup (EDIT SETUP) Value: Description of choice: Function: 007 LCP copy (LCP COPY) Value: Description of choice: