How to Use Start Vacuuming & Mopping 1. Take out the 2-in-1 dust compartment with water tank, open the plug, fill with clean water, and then refasten the plug. Install the 2-in-1 dust compartment with water tank onto the robot vacuum in the direction indicated in the figure, and make sure that the clip is firmly clasped. 3. Press the buton to start vacuuming and mopping. Clip Plug It is properly installed when you hear a "click". Open the plug and add water. CAUTIONS: Remove the 2-in-1 dust compartment with water tank and pour out the lefover water in a timely manner afer a mopping task has been completed. Then clean and dry the mop pad to prevent odor and mildew.
When the robot vacuum is running, please set up virtual walls or restricted areas for carpeted areas in your home to avoid the robot vacuum from becoming entangled in the carpet. CAUTIONS: Please remove the 2-in-1 dust compartment with water tank before adding water. Do not add liquids such as hot water, detergent, or disinfectant to prevent damaging the robot vacuum. Due to production testing, the 2-in-1 dust compartment with water tank may have water stains, which is normal. 2. Before using the vacuuming & mopping function, dampen the mop pad and wring it out and then install it onto the mop pad holder.
Slide the mop pad holder along the botom of the robot vacuum horizontally in the direction indicated in the figure until it clicks into place. If only vacuuming function is needed, please remove the mop pad holder. Clips Press the clips and pull the mop pad holder out. ş Š š 09