2. Untwist and remove the filter from the pre-filter, then pull out the sponge filter from the filter. Cleaning the Dust Sensor Remove the dust compartment and filter assembly, then clean the sensor area with a sof dry cloth. Pre-filter Fliter Sponge Filter 3. Rinse the dust compartment, pre-filter, filter, and sponge filter under running tap water until clean, then set aside all parts to fully dry for at least 24 hours. 1. Place the brush head upside down on a flat surface so the brush bar faces upward. Push the brush release buton in the direction indicated by the arrow until the cover of the brush head pops open, then remove the brush bar by lifing it in the direction indicated.
• Clean the filter, then rinse it out and lightly tap on the edge of the filter to remove dust and debris. • Do not touch the surface of the filter or sponge filter with hands, brush, or sharp objects to avoid damaging the filter. • Do not immerse the filter in water. • If the suction power is still significantly reduced afer the filter assembly is cleaned, you can try to replace with a new genuine filter. Cleaning the Electric Tangle-free Brush Bar Notes: 24h 11