en Cleaning and servicing Warning! Prevent the cut ingredients from building up in the outlet opening. ■ ■Add ingredients. Maximum amount of liquid = 1.25 litres; maximum amount of frothing or hot liquids = 0.5 litres; Optimal processing capacity – solids = 50-100 g; ■ ■Attach the cover and turn anti-clockwise Tip: To ensure even cutting results, process thin ingredients in bunches. Note: If the food to be processed sticks in the continuous-feed shredder, switch food processor off, pull out mains plug, wait until the drive comes to a standstill, remove cover from the continuous-feed shredder and empty feed tube. all the way into the blender handle. The cover must be locked in position.
■ ■Set the rotary switch to the desired setting. After using the appliance Adding more ingredients Fig. J-8: ■ ■Switch off the appliance with the rotary switch. ■ ■Rotate the continuous-feed shredder in ■ ■Switch off the appliance with the rotary an anti-clockwise direction and remove. ■ ■Rotate the lid in an anti-clockwise direc- tion and remove. ■ ■Remove disc holder with disc. To do this, switch. ■ ■Remove the lid and add ingredients or ■ ■remove the funnel and gradually add solid press finger from below against the drive shaft (Fig. H ) . ■ ■Clean parts. ingredients through the refill opening or ■ ■pour liquid ingredients through the funnel.
After using the appliance Blender ■ ■Switch off the appliance with the rotary W W Risk of injury from sharp blades / rotating drive! Never place fingers in the attached blender! Do not remove / attach the blender until the drive is at a standstill! Operate the assem- bled blender only and with the lid attached. switch. ■ ■Rotate the blender in a clockwise direc- tion and remove. Tip: It is recommended to clean the blender immediately after use. W W Risk of scalding! If processing hot liquids, steam escapes through the funnel in the lid. Add a max. 0,5 litres of hot or frothing liquid. Cleaning and servicing Attention! Do not use abrasive cleaning agents. Sur- faces may be damaged. Warning!
Blender may be damaged. Do not process deep-frozen ingredients (except ice cubes). Do not operate blender when empty. Cleaning the base unit W W Danger of electric shock! Never immerse the base unit in water or place under running water. Do not use a steam cleaner. Working with the blender Fig. J : ■ ■Press the release button and ■ ■Remove mains plug. ■ ■Wipe the base unit and drive cover with move the swivel arm to position 4 . ■ ■Remove the blender drive cover. a damp cloth. If required, use a little detergent. ■ ■Then dry the base unit. ■ ■Attach blender jug (mark on the handle on mark on the base unit) and turn all the way in an anti-clockwise direction.
24 124_MUM58xxx_8001027214.indb 24 27.11.2015 15:11:46