HOME sm00946 sm00950 Figure 3-16.Triple Sprocket Fastener Figure 3-19. Snap Ring 17. See Figure 3-20 . Slide snap ring, washer, and ball clutch . Install TAPPET COMPRESSING c. Tighten 19 mm nut to compress tappets. 19. See Figure 3-22 . Remove secondary cam chain tensioner. sm00948 sm00951 Figure 3-18. Starter Limiter Gear Assembly Figure 3-20. Snap Ring and Ball Clutch Gear 2009 VRSC Service: Engine 3-21 gear with needle roller and sm00947 shaft. NOT • If the crankshaft rotates slig piston TDC. • For the following procedure pre-loaded. 18. See Figure 3-21. Install TOOL (Part No. HD-45491) assembly. a. Loosen 19 mm nut on b. Tools are marked intak Figure 3-17. Rotor Shell accordingly.
gear with needle roller and shaft. NOT • If the crankshaft rotates slig piston TDC. • For the following procedure pre-loaded. 18. See Figure 3-21. Install TOOL (Part No. HD-45491) assembly. a. Loosen 19 mm nut on b. Tools are marked intak accordingly. Figure 3-17. Rotor Shell