HOME sm04538 sm01027 Figure 3-51. Lubricate Journal Caps and Fasteners Figure 3-50. Lubricate Cam 7. See Figure 3-49 8. timing mark labeled IN (7). 9. See Figure 3-49 a. sprocket. b. sprocket. c. The three dot timing line (10) on the intake cam sprocket is aligned with the four dot timing line (11) on the exhaust cam sprocket. Figure 3-52. Cam Journal Cap Numbering and Directional Arrow (exhaust cam shown) d. The rear intake and exhaust cam lobes (9, 12) are positioned as illustrated. 10. See Figure 3-51 . Lubricate cam journal caps and fasteners. 11. See Figure 3-52 . Cam journal caps are numbered. Install cam journal caps with corresponding number on head, arrow pointing to center of head.
12. Tighten cam journal caps to 9.7 Nm (86 in-lbs ). 13. See Figure 3-53 . Install rear cylinder cam chain tensioner and tighten to 100 Nm (74 ft-lbs). 3-30 2009 VRSC Service: Engine haust cam into cylinder o single copper link (14) ark labeled as EX (13). der head and rotate cam ) straddles the single dot linder, verify that: on the cam drive chain t (7) on the intake cam on the cam drive chain (13) on the exhaust cam sm04539