HOME 7. Subtract the valve stem measurement from the valve guide bore measurement to calculate the running clearance. 8. Compare the measurements to Table 3-21 . Table 3-21. Valve Guide Running Clearance 0.0012 IN 0.0023 0.0016 0.0026 NOTE Do not remove valve guides within valve guide running clear- ance. Refer to Table 3-21 . 9. See Figure 3-69 . Remove and replace the valve guides 2009 VRSC Service: Engine 3-37 sm01044 sm01045 Figure 3-69. Valve Guide Removal (typical) 10. See Figure 3-70. Measure cylinder head valve guide bore to determine valve guide diameter needed. Select valve guide no larger than 0.051 mm (0.0020 in.) to 0.022 mm (0.00086 in.) over size of cylinder bore. 11.
See Figure 3-71. Use VALVE GUIDE REMOVER/INSTALLER (Part No. HD-45320) to install valve guide at correct height. Figure 3-68. Measure Stem to Guide Clearance sm01045 Figure 3-68. Measure Stem to Guide Clearanc VALVE GUIDE MM Intake Min 0.0285 Max 0.0585 Exhaust Min 0.0385 Max 0.0685 that do not meet spe of valve guide. Us cifications. Position head for removal e CYLINDER HEAD SUPPORT -39782) with CYLINDER SUPPORT HD-39782-13) for intake valves and RT ADAPTER (Part No. HD-39782- s. 2009 VRS STAND (Part No. HD -39782) with ADAPTER (Part No. HD-39782-13) CYLINDER SUPPO 14)