HOME VALVE SEAT REFACING sm01036 TOOL NAME PART NUMBER VALVE GUIDE CLEANING BRUSH HD-34751 NEWAY VALVE SEAT CUTTER SET HD-35758-50 CYLINDER HEAD HOLDING FIXTURE HD-39786 CYLINDER HEAD HOLDER HD-45333 Verify correct valve stem to valve guide clearance before refacing. Refer to Table 3-22 . If new guides must be installed, complete that task before refacing valves and seats. NOTE NOTE This procedure is not based on the lapping of valves. The end result is an interference fit between the valve of 45 degrees and the valve seat which will be 46 degrees. 1. See Figure 3-79 . Use CYLINDER HEAD HOLDING FIX- TURE (Part No. HD-39786) and CYLINDER HEAD HOLDER (Part No.
HD-45333) to secure cylinder head for service. Figure 3-79. Cylinder Head Holder 5. From the NEWAY VALVE SEAT CUTTER SET (Part No. HD-35758-50) use # 622 and cut intake (# 203 for exhaust) valve seat angle to 46 degrees. Do not remove any more metal than is necessary to clean up the seat (that is, to provide a uniform finish and remove pitting). 2. Clean valve seats and valve faces. 3. Insert the valve stem into the valve guide. Push on the bottom of valve until it contacts the valve seat. 6. In order to determine the correct location of the 46 degree valve seat in the head, measure the width of the valve to be used and subtract 1.02 mm (0.040 in.) from that 4. Measure valve stem protrusion.
a. head. b. for exhaust or intake valve. Refer to c. If valve stem protrusion is longer than the maximum, replace valve seat or cylinder head as necessary. Use a permanent marker to highlight the valve seat area that is going to be cut and be sure to highlight all 3 angles. Allow marker to dry before proceeding. d. If valve stem protrusion is less than the minimum, measure distanc spring pocket in c maximum and mi Refer to Table 3-2 nger than the ma e from be used and subtr ylinder number. 7. Set your dial caliper nimum down for quick refer 2. seat. ximum, 8. Use a permanent m protrusion is within maximum and minimum specific- sm01056 ations. Table 3-22.
Valve Stem Protrusion ITEM MM IN Intake Max 44.771 1.762 Min 44.171 1.739 Exhaust Max 43.893 1.728 Min 43.293 1.704 Figure 3-80. Mark Valve Seat NOTE Always be sure cutter blades and cutter pilot are clean before beginning the cutting process. The correct cleaning brush is supplied with the Neway tool set. Also be sure the inside of 2009 VRSC Service: Engine 3-41 sm01056 Figure 3-80. Mark V NOTE Always be sure cutter blades and cu beginning the cutting process. The supplied with the Neway tool set. A 2009 VRS alve Seat tter pilot are clean before correct cleaning brush is lso be sure the inside of C Service: Engine 3-41 ITEM MM Intake Max 44.771 Min 44.171 Exhaust Max 43.893 Min 43.293