HOME the valve guide is clean by using Kent-Moore VALVE GUIDE CLEANING BRUSH (Part No. HD-34751). • Due to using the top measurement of our valve seat as a reference point it will usually be necessary to use the 31 degree cutter following the initial 46 degree cut. NOTES 9. Choose the cutter pilot that fits properly into the valve guide hole and securely seat the pilot by pushing down and turning using the installation tool supplied in the tool set. • Do not cut the bottom angle on the exhaust seat. 10. Choose the proper 46 degree cutter (intake or exhaust) and gently slide the cutter onto the pilot being careful not to drop the cutter onto the seat.
• Always highlight the valve seat with the permanent marker in order to verify the location of the 46 degree valve seat. 13. If the location of the valve seat is not correct, repeat steps 6 through 8. sm01057 14. When you accomplish a complete clean-up of the 46 degree angle and the width is at least 0.750 mm (0.029 in.) for intake or 1.050 mm (0.041 in.) for exhaust, proceed to the next step. 15. Select the proper 70 degree cutter (for intake) and gently slide the cutter down the cutter pilot to the valve seat.The exhaust does not have a bottom angle. 16. See Figure 3-78 . Remove just enough material to provide the proper valve seat width. 17.
Remove cutter pilot and wash head thoroughly and dry completely. 18. Repeat the process on any valve seat that needs service. 19. Insert valve to be used in the valve guide and bottom on the valve seat. Positioning the cylinder head port upwards and with slight thumb pressure against the valve, com- Figure 3-81. Neway Cutter 11. 46 degree angle. NOTE or defects and, if necessary, repeat the above cutting process. NOTES • If the width of the clean-up angle is greater on one side of the seat than the other, the guide may need to be replaced due to improper installation.
HEAD ASSEMBLY TOOL NAME PART NUMBER • After making the 46 degree cut, if you discover a groove cut completely around the seat this means the blades of the cutter are in alignment and need to be staggered.This is accomplished by loosening all of the blades from the cutter body and moving each blade slightly in its cradle in opposite directions on the cutter. The tool needed to loosen the blades is supplied in the tool set. Making a mark every 90 degrees with a permanent marker will help in determining where new angles are. VALVE SPRING COMPRESSOR HD-34736-B VALVE GUIDE SEAL INSTALLER HD-45322 1. Thoroughly clean head before beginning assembly. 2. See Figure 3-82 . Insert lower spring collar.
3. Lubricate valve with Harley-Davidson Motorcycle Oil 20W50 and position in cylinder head. 4. See Figure 3-83 . Place VALVE GUIDE SEAL INSTALLER (Part No. HD-45322) tapered pin over valve stem and position new seal on the tapered pin. Drive seal into position. 12. Next, with your dial caliper locked to the predetermined setting, measure the 46 degree cut at the outer most edge at the widest point of the circle to determine what cut needs to be made next. a. If the 46 degree cut is too high (towards the combus- tion chamber), use the 31 degree cutter to lower the valve seat closer to the port. b.
If the 46 degree cut is too low, and the width of the valve seat is too wide, use the 70 degree (intake only) cutter to raise the valve seat or move it away from the port. 3-42 2009 VRSC Service: Engine Cutter nsistent pressure, r omplete clean-up pletely fill the port between the valve a emove on the Hold pressure against th If any leakage occurs, ex