2009 — Head Assembly

HOME sm01058 5. See Figure 3-84 . Install upper spring collar and valve spring and with tightly wound coils to the bottom. 6. See Figure 3-85 . Install VALVE SPRING COM- PRESSOR (Part No. HD-34736-B) and compress spring to expose valve stem. Apply a light grease around the valve stem to hold keepers in position when relaxing the compressor tool. 7. Install valve keepers and remove compressor tool. 8. Using a micrometer measure and record for reference all valve shims. 9. Install all valve shims in their original location. Use a magnet to position the shim and push into place with finger. Figure 3-82. Lower Spring Collar 10. Reinstall tappets in their original locations. 11.

Lubricate cam journals, lobes, and tappets with Harley- Davidson Motorcycle Oil 20W50. In addition, a thin film of Lubriplate No. 105 Motor Assembly Grease (NAPA Part sm01059 No. 765-2651) is recommended. 12. See Figure 3-86. Install cams and cam journal caps. Tighten cam journal caps to 9.7 Nm (86 in-lbs). NOTE To accurately check valve lash, cam journal caps MUST be tightened to 9.7 Nm (86 in-lbs). 13. See Figure 3-87. Using a blade type feeler gauge measure valve lash. See 1.25 VALVE LASH, Lash Measurement and D.2 VALVE LASH CALCULATION WORKSHEET 1. 14. Adjust valve lash as required. NOTE Valve lash can be measured and adjusted before the heads are installed on engine.

However, after head installation, valve lash should be measured and adjusted as required. sm01041 Figure 3-84. Valve Spring Coils Figure 3-83. Valve Seal Installation 2009 VRSC Service: Engine 3-43 Figure 3-84. Valve S Valve Seal Installation 2009 VRS pring Coils C Service: Engine 3-43 Figure 3-83.