2009 — Disassembly

HOME sm01071 sm01005 Figure 3-97. Remove Clutch Assembly Figure 3-98. Crank Held to Loosen Fastener 9. Remove oil pump from case. See 3.12 OIL PUMP . 10. Using a 1/2 in. drive extension and breaker bar, rotate engine in direction of normal engine rotation until timing marks on the crank gear and counterbalancer gear are aligned. sm01074 Do not use Counterbalancer Alignment Pin to remove or tighten counterbalancer fastener. Pin can bend and bind in hole. (00550b) 11. See Figure 3-98 . Hold crankshaft with 1/2 in. drive exten- sion and wrench to loosen counterbalancer drive gear fastener. The gear and fastener can be left in place or removed.

• The counterbalancer gear fastener can only be broken loose before the case halves are separated and the crankshaft is still in place. NOTES Figure 3-99. Oil Pan Removal • If the alternator rotor is to be removed from the crankshaft, the rotor fastener can be broken loose while holding the crankshaft drive gear with a 1/2 in. drive extension and wrench. sm01075 • If the starter limiter gear is to be removed, the starter limiter fastener can be broken loose while holding the crankshaft drive gear with a 1/2 in. drive extension and wrench.

• If the cam drive is to be removed as part of top end disas- sembly, break loose the cam drive triple sprocket while holding the crankshaft drive gear with a 1/2 in. extension and wrench. 12. See Figure 3-99 . Carefully invert engine. Remove oil pan. Note position of engine ground cable for assembly. Figure 3-100. Oil Pickup 13. See Figure 3-100 . Remove oil pickup and gasket/baffle. 14. See Figure 3-101. Loosen, but bearing retainer fasteners. 15. See Figure 3-102. Install TRA RETAINER TOOL (Part No. HD- 16. See Figure 3-103. Loosen all fou fasteners. Remove the two faste 2009 VRS do not remove, the input TRA NSMISSION ASSEMBLY 45301)