HOME sm01109 11. See Figure 3-114 . If rods are to be reused, mark them F (front) and R (rear). Rod must be installed in the same position. sm01105 Figure 3-115. Bearing Shells 12. See Figure 3-115 . Inspect bearing shells for scoring or discoloration. sm01112 Figure 3-113. Measure Journal 10. See Figure 3-113 . Measure crankshaft journals. For crankshaft bearing selection. Refer to Table 3-24 . sm01110 Figure 3-116. Remove Pistons 13. See Figure 3-116 . Carefully push piston and rod out top of cylinder. Avoid contacting piston jet. Do not let the connecting rod contact the cylinder liner wall. Mark Connecting Rods e: Engine Figure 3-114. 3-52 2009 VRSC Servic