HOME sm01105 Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 15. See Figure 3-118 . Note rod and cap identifying numbers No. Snap-on TA360) per instruction sheet and tighten connecting rod bolts an additional 90 degrees. NOTE The notation for this torque sequence is written: Figure 3-117. Wrist Pin Retaining Rings 27 Nm + 90 degrees. 16. See Figure 3-119 . Check big end dimensions with a dial bore gauge. Measurement must be between a maximum of 51.616 mm (2.032 in.) and a minimum of 51.60 mm (2.031 in.). 14. See Figure 3-117 .
Remove and discard wrist pin retaining rings using PISTON PIN REMOVAL AND INSTALLATION TOOL (Part No. HD-47189). 17. See Figure 3-120 . Inspect small end bushing and wrist pin fit. The running clearance should be between a max- imum of 0.033 mm (0.001 in.) and a minimum of 0.018 mm (0.0007 in.). NOTE If new pistons are not to be used, do not remove pistons. tall rod caps and tighten to 27 Nm TORQUE ANGLE GAUGE (Part sm01114 sm01105 Figure 3-118. Install Rod Caps for Inspection Figure 3-119. Measure Big End 2009 VRSC Service: Engine 3-53 sm01105 all Rod Caps for Inspection Figure 3-119. Meas 2009 VR Figure 3-118. Inst ure Big End SC Service: Engine 3-53