2009 — Crankshaft, Piston and Cylinder Liner Removal/Installation

HOME 30. See Figure 3-133 . Lubricate O-rings with Harley-Davidson Motorcycle Oil 20W50 to keep O-rings seated on cylinder. sm01138 31. See Figure 3-134 . Align case and cylinder marks and insert liner in the case bore. Install CYLINDER LINER REMOVER/INSTALLER according to instruction sheet and install liner. 32. See Figure 3-135 . Check ring end gap by placing ring in cylinder and measure gap using feeler gauges. See spe- cifications for serviceability. 33. See Figure 3-136 . Carefully install piston rings. Second compression ring is installed with the mark to the top. When ring set is installed, gaps must be staggered.

NOTE If engine is to be assembled at this point, make sure all parts are cleaned and lubricated appropriately. Figure 3-136. Second Compression Ring Top Mark toward the crankcase. Orient the squeeze handle parallel to crankcase. Figure 3-135. Ring End Gap NOTE Failure to install pistons correctly oriented will result in engine failure. c. Orient piston and connecting rod to crankcase. 3-58 2009 VRSC Service: Engine Wear safety glasses or goggles when removing or installing retaining rings. Retaining rings can slip from the pliers and could be propelled with enough force to cause serious eye injury. (00312a) 34. See Figure 3-137.

Install wrist pin and wrist pin retaining rings using PISTON PIN REMOVAL AND INSTALLATION TOOL (Part No. HD-47189). sm01105 sm01105 Figure 3-137. Wrist Pin Retaining Rings 35. See Figure 3-139. To install piston, complete each of the following steps: a. Lightly lubricate inside of PISTON RING COM- PRESSOR (Part No. HD-96333-105) and rings and piston skirt with Harley-Davidson Motorcycle Oil 20W50. b. See Figure 3-138. Orient the brackets on the com- pressor ring down (note arrow on compression ring)