HOME Figure 3-138. Piston Ring Compressor 37. See Figure 3-143 . Select rod bearing replacement set to match rod bearing journal diameter color code (3) on crankshaft. Refer to Table 3-23 . NOTE Rod bearing sets (front and rear) are available in two sizes, coded red (R) and blue (B).The rod bearing color code appears on the bearing shell edge. Always measure all bearing surfaces before selecting and installing bearings. 2009 VRSC Service: Engine 3-59 NOTE Correct piston and connecting rod orientation is as follows: d. Front cylinder connecting rod and cap bumps to cam drive side of engine e. Rear cylinder connecting rod and cap bumps to water pump side of engine f.
EX mark toward the front on front cylinder g. EX mark toward the rear on rear cylinder h. Clamp the PISTON RING COMPRESSOR around rings and pistons. i. Adjust tension on handle to compress rings, but still allow piston and rings to slip out of compressor into cylinder bore. NOTE If piston jet is damaged, crankcase will have to be replaced. j. See Figure 3-131. With free hand inside crankcase, guide rod past piston jet. NOTE Whenever resistance is encountered, stop and examine components. A ring can gouge the cylinder wall when forced. k. See Figure 3-139. Using a rubber or wooden mallet handle, very gently tap piston around circumference into bore.
Hold constant pressure on the piston ring compressor until rings have entered bore. l. When piston and rings are in the bore, move piston up and down the bore to verify rings have not broken during installation. sm01105 sm01141 Figure 3-139. Insert Piston 36. Invert upper crankcase assembly. Clean connecting rod bore and crank bore making sure it is free of oil.